Hood blowers and housings
Chloride pits the blower wheel and the galvanised housing behind the baffles. You hear it first as a rattle at high speed, then as a drop in capture over the burners.
Independent service company · Wolf cooking equipment only
Mon–Fri 8–6 · Sat 9–4
Jacksonville Beach · Atlantic Beach · Neptune Beach · Ponte Vedra
We are an independent repair company working one manufacturer and one stretch of coast: Wolf ranges, rangetops, cooktops, wall ovens, steam ovens and ventilation, from the 1st-to-5th Street core out to Ponte Vedra.
$129 flat diagnostic, credited toward the repair · You get a written estimate before any part is ordered or any labor begins. · 90 days on labor, 365 days on parts.
What a visit costs · Warranty · Questions we get asked · About us
Nothing on this page is a general statement about appliances. It is what we pull apart on this island, in this ZIP code, week after week.
Chloride pits the blower wheel and the galvanised housing behind the baffles. You hear it first as a rattle at high speed, then as a drop in capture over the burners.
Cast grate feet corrode where they sit in the well. Caps pit at the port ring, so the flame goes yellow and lopsided and the igniter starts clicking after the burner is already lit.
Surface rust blooms on trim and handles within a season of moving here. Oven door hinges stiffen and the door stops closing square against the gasket.
An outdoor grill on an open deck takes everything the ocean has. Burners, valves and igniter leads corrode years faster than the same parts under a roof.
One manufacturer only. We do not service other brands, and we will say so on the phone rather than waste your morning.
Four ZIP codes on one barrier island and the strip behind it. Short drives mean the common ignition, hinge and blower parts are already on the van, and a fault we can identify on the phone often gets fixed on the first visit rather than the second.
Owner reports
4.4 out of 5 from 54 published reports. Each one is a single visit, in the words of the person who paid for it.
Two knobs had seized solid out on the deck. He stripped and regreased the valve stems rather than replacing the whole manifold, which is what the last company out here had quoted me for.
Landon F.
It kept shutting off and the first visit did not find it. He came back, went further into the boards and found a failing fan. Fixed in the end, but it took two trips and a fortnight to get there.
Roslyn A.
Steam production had dropped away to almost nothing. There was heavy scale in the generator from our water. He descaled it thoroughly and set out a routine for me so that it does not build back up so quickly.
Ivan S.
Tell us the model and what it is doing. We come to the island, find the fault, and put the number in writing.